05-05-2012, Saturday-23:56:00
Ein Auszug aus dem Wiki:
# Max number of steps in goods pathfinding
# This should be equal or greater than the biggest group
# of interconnected stations in your game.
#
# If you set it too low, some goods might not find a route
# if the route is too complex. If you set it too high, the
# search will take a lot of CPU power, particularly if searches
# often fail because there is no route.
#
# Depending on your CPU power, you might want to limit the search
# depth.
#
# 300 seems to be a good compromise for most games. 100 is ok for
# small games. 8000 should suffice for even the largest maps, but
# will take a good amount of CPU time if you have complex transport
# networks. Max. allowed value is 9994.
#
# T. Kubes: 1000 should be enough even for biggest games I have seen so far.
# prissi: On a 512x512 map with more than 150000 people daily, the saturation
# value for "no route" was higher, around 8000. Using 300 instead almost doubled
# the value of "no route"
#
max_hops = 1000
Der Parameter definiert die Gesamtzahl geprüfter Haltestellen beim Versuch, eine Route für ein neu erzeugtes Warenpaket (ebenso Fahrgäste) zu finden.
Bei großen Karten mit vielen Stationen kann es passieren, das das Passagieraufkommen plötzlich einbricht (diese finden dann keine Route mehr). Dann den Wert dieses Parameters vergrößern.
Das Du den Wert max_transfers höherstellen musstest, verwundert nicht, wenn man Deine Spiele mal gesehen hat.
# Max number of steps in goods pathfinding
# This should be equal or greater than the biggest group
# of interconnected stations in your game.
#
# If you set it too low, some goods might not find a route
# if the route is too complex. If you set it too high, the
# search will take a lot of CPU power, particularly if searches
# often fail because there is no route.
#
# Depending on your CPU power, you might want to limit the search
# depth.
#
# 300 seems to be a good compromise for most games. 100 is ok for
# small games. 8000 should suffice for even the largest maps, but
# will take a good amount of CPU time if you have complex transport
# networks. Max. allowed value is 9994.
#
# T. Kubes: 1000 should be enough even for biggest games I have seen so far.
# prissi: On a 512x512 map with more than 150000 people daily, the saturation
# value for "no route" was higher, around 8000. Using 300 instead almost doubled
# the value of "no route"
#
max_hops = 1000
Der Parameter definiert die Gesamtzahl geprüfter Haltestellen beim Versuch, eine Route für ein neu erzeugtes Warenpaket (ebenso Fahrgäste) zu finden.
Bei großen Karten mit vielen Stationen kann es passieren, das das Passagieraufkommen plötzlich einbricht (diese finden dann keine Route mehr). Dann den Wert dieses Parameters vergrößern.
Das Du den Wert max_transfers höherstellen musstest, verwundert nicht, wenn man Deine Spiele mal gesehen hat.